Plastic H Section - Made to Order or from Stock

Tubeway manufacture and stock plastic H Section for use in the construction, shopfitting and exhibition industries. They can be used for different sheet materials, such as wallboard, panel, plywood, foamex and glass, and because they will generally have tapering legs, they can be used to join covered boards or display materials. There are different designs of the H Sections, depending on your application, such as Butt Joints with parallel legs and 2 Part H section where the base section can be fitted, the wallboards butted and fixed, then the top section pressed in to cap the joint.

We can supply plastic H Section in several ways:

• from our wide stock range, as detailed below,
• from a production run of 500m+ with a stock H Section, Butt Joint or 2 part H section tool,
• from a production run with one of the additional plastic H Section tools listed further down,
• from a new tool, cut to the shape and size you need.

For more information or to discuss your requirements, please contact us with your Plastic H Section requirements.

If you need other plastic profiles that complement our plastic H Section, you can click through to our clip on edging, plastic capping, plastic T sections and plastic corner profiles pages.

Stock Plastic H Section

Tubeway manufacture plastic H Sections, Butt Joints and 2 Part H Sections at our UK factory, holding plenty of stock in different colours that is replenished within usually 2-3 days. Buy online for quick delivery, by following the links in each table.

2 PART H SECTION

Production Plastic H Section

For large quantities of H Section it can be very cost effective to look at a production run. This not only saves you money over multiple stock packs, but gives you the choice of many more sizes and colours, as well as non-standard lengths for the order.

We hope you find what you want in the tooling listed below, but please remember that you can cut new tooling at low cost and short lead time should it be required.

H Section, in its different variations (Butt Joint, Unequal H Section, 2 part H Section, Division Bar) is generally used to provide a joint between two panels of equal thickness in a large display, fitting or installation. The legs on either side of the H serve also to cap and protect the edge of the panel, whatever it is made of, and provide a rigid division which may form part of the intended aesthetics of the whole construction. The legs can usually have the angles altered to suit during production, to cater for boards of variable thickness, or to alter the amount of grip onto them.

For more information on all of these products, particularly the combinations of 2 Part H Section for each board size, or any queries about the manufacture or use of Tubeway's Plastic H Section, please contact our Sales team